(4) Install the ballast (2) and retain with two screws
(5)
Remove the terminal block (6) by releasing two
screws (5).
block.
d. Reassembly.
(5)
Dress and group wires and tape them into a
(1)
Install the terminal block (6) with two screws (5).
harness.
(2)
Install the fluorescent tube socket (9) with two
(6) Insert starter (8) in socket (11).
Insert
screws (10).
Dress wires to terminal block and attach to
fluorescent tube (1) in socket (9) and rotate to lock.
terminals.
e. Installation. Install the light box assembly. Refer to
(3) Position starter socket (11) on light box and
retain with two screws (10) and nuts. Dress wires to terminal
block and attach to terminals.
Figure 4-24. Light box assembly.
assembly (3) and is interconnected to the diverter valve plate
4-49. Transparency Holder Housing and Diverter Valve
assembly through two valve guides (5, fig. 4-25) secured to the
Plate Assembly
back of the housing. The diverter valve plate (2) riding on the
a. Description.
The transparency holder housing (2, fig.
valve guides,
1-6) is
supported by
the axle and tube
4-27