TM 11-7025-232-10
Table 3-1.
T r o u b l e s h o o t i n g -- Continued
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
33.
STATUS CODE 30 (BAD VFU MEMORY).
p e r s i s t s , t e l l your supervisor maintenance is required.
If
fault
STATUS CODE 40 (BAND SPEED FAULT).
34.
Step 1.
Check cleanliness of character band area.
Step 2. C h e c k that no more than six-part paper is installed in printer.
I n s t a l l no more than six-part paper (para 2-8). If fault
p e r s i s t s , tell your supervisor maintenance is required.
STATUS COXDE 41 (PAPER DRIVE/CLAMP SYSTEM FAULT).
35.
I f fault persists, tell your supervisor maintenance is required.
STATUS CODE 42 (ODD HAMMER SYSTEM FAULT).
36.
I f f a u l t p e r s i s t s , t e l l your supervisor maintenance is required.
STATUS CODE 43 (EVEN HAMMER SYSTEM FAULT).
37.
p e r s i s t s , t e l l your supervisor maintenance is required.
If
fault
STATUS CODE 44 (+12 VOLT FAULT).
38.
I f fault persists, tell your supervisor maintenance is required.
STATUS CODE 45 (-9 VOLT FAULT).
39.
I f fault persists, tell your supervisor maintenance is required.
STATUS CODE 46 (VCL FAULT).
40.
I f fault persists, tell your supervisor maintenance is required.
STATUS CODE 47 (+38 VOLT FAULT).
41.
I f fault persists, tell your supervisor maintenance is required.
STATUS CODE 48 (TRANSDUCER FAULT).
42.
Power OFF, then power ON printer.
I f f a u l t p e r s i s t s , t e l l your supervisor maintenance is required.
3-8