TM 11-7025-232-10
Table 3-1.
T r o u b l e s h o o t i n g -- Continued
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Step 3.
Check alinement of paper pin-feed holes on sprocket pins.
Aline pin-feed holes on sprocket pins, and press ALARM/CLEAR
switch.
Step 4.
Check if paper release lever is down in locked position.
Push paper release lever down into locked position, and press
A L A R M / C L E A R switch. If fault persists, tell your supervisor
maintenance is required.
6.
STATUS CODE 03 (CHARACTER BAND NOT TIGHT, OR BAND COVER NOT CLOSED).
Check character band tension.
Step 1.
A d j u s t character band tension (para 3-5).
Check band cover.
Step 2.
Close band cover. I f f a u l t p e r s i s t s , t e l l y o u r s u p e r v i s o r
maintenance is required.
7.
STATUS CODE 04 (HAMMER BANK NOT CLOSED).
Check hammer bank position.
Press down hammer bank latch handle into locked posistion. If
fault persists, tell your supervisor maintenance is required.
8.
STATUS CODE 05 (UNDEFINED CHARACTER BAND).
Check character band for sets of 96 characters.
I n s t a l l proper character band (para 2-10), and press
ALARM/CLEAR switch. I f f a u l t p e r s i s t s , t e l l y o u r s u p e r v i s o r
m a i n t e n a n c e is required.
STATUS CODE 06 (RIBBON MOTION FAULT).
9.
Check ribbon motion path (para 3-4).
Step 1.
Clear ribbon jam, and press ALARM/CLEAR switch.
Step 2.
C h e c k ribbon cartridge (para 3-4).
Adjust ribbon cartridge, and press ALARM/CLEAR switch.
3-3
