Figure 6-7. Operating rod assembly, exploded view.
6-15. Copyboard Cleaning and Inspection
Clean all parts thoroughly with a cleaning solvent and dry with
Figure 6-5. Copyboard, front exploded view.
compressed air, being careful to remove all dirt or cleaning
solvent from Copyboard front plate perforations. Inspect all
threaded parts and tapped holes for stripped or damaged
threads. Replace any damaged parts. Inspect Copyboard front
plate and replace if warped. Inspect operating gates and shaft
for worn or damaged condition. Inspect operating gears and
spacers for signs of excessive wear or damage. Inspect cross
braces for warping or distortion. Inspect Copyboard flange for
cracked or broken condition. Check the operating rod rack and
its related parts for wear. Replace all defective parts.
6-16. Copyboard Reassembly
a. Reassembly.
(1) Position the Copyboard form rib (8, fig. 6-5) and
secure with screws (9 and 71.
(2) Install screw (4). Insert operating shaft (5) in
operating gate (3) and insert onto screw (4-. Insert shaft
through hole in Copyboard back plate assembly (1) and swing
gate to closed position. In a similar manner, install remaining
two operating gates .
(3) Slide an operating gear (19, fig. 6-6) shaft and
retain each with setscrew (8). Do not tighten setscrews at this
time. Install screw (2).
(4) Reassemble the operating rod assembly (2) in
the following manner:
(a) Tap dowel (6, fig. 6-7) into operating
rod (7) and position block (5) on dowel. Turn operating rod over
and insert hex socket head screw /8 (to secure block.
Figure 6-6. Copyboard, rear exploded view.
6-7
