TM 11-7025-232-10
INITIAL SETUP
M a t e r i a l s / S p a r e Parts
Common Tools
Isopropyl alcohol
Stiff bristle
brush
1. Power OFF printer (para 2-7).
2 . Pull ac power plug from outlet.
3. Open operator door.
4. Lift up hammer bank latch handle to
open hammer bank.
5. Remove ribbon cartridge (para 2-9,
R e m o v e , steps 4-6).
6. Remove character band (para 2-10,
R e m o v e , steps 6-10).
WARNING
Top edges of band are sharp. Avoid
contact.
7. Place character band in a shallow
pan.
WARNING
I s o p r o p y l alcohol is flammable.
Keep away from high heat or open
flame.
8 . Place isopropyl alcohol in bottle
equipped with spray nozzle.
9. Saturate band.
1 0 . Using a small stiff bristle brush,
c l e a n type faces thoroughly.
11. Clean both sides of entire band.
12. Allow band to drip dry.
