TM 11-7025-210-23
4-38. REMOVE/REPLACE JACKSHAFT AND LINEFEED CLUTCH (CONT)
5.
Put on left jackshaft pulley.
6.
Use feeler gauge to set 0.003-0.008 in. (0.08-
0.20 mm) gap between pulley and bearing.
7.
Tighten set screws on pulley.
8.
Replace left drive belt (para 4-33,
Replace
steps 1-9).
9.
Put on right jackshaft pulley.
10.
Use feeler gauge to check jackshaft end
position. It should be flush to 0.06 in. (1.5 mm)
beyond outside edge of pulley.
11.
Tighten set screws.
12
Tighten two set screws on strobe disc.
13.
Replace right drive belt (para 4-32,
Replace
steps 1-5).
14.
Push plug in hole.
15.
Adjust strobe detector assembly (para 4-42).
16.
Adjust linefeed solenoid (para 4-44 steps 2-14).
17.
Close up line printer (para 4-18).
18.
Power on.
19.
On control panel, press TEST button.
20.
Power off.
21.
Push printer back in place.
4-86
