TM 11-7025-210-23
4-42. ADJUST STROBE DETECTOR ASSEMBLY
INITIAL SETUP
Common Tools
Test Measurement and Diagnostic Equipment
Tool kit
Oscilloscope (Method B only)
NOTE
There are two ways to make this
adjustment. Method A is a rough
adjustment. Method B is a precise
adjustment but requires more time.
Always try method A first. Method A 1.
Access line printer (para 4-18).
Method A
1.
Access line printer (para 4-18).
2.
Turn motor drive pulley counter-clockwise.
NOTE
Solenoid arm engages clutch lobe when
clutch and strobe disc will not turn.
3.
Check if linefeed solenoid arm engages
clutch lobe.
4-95
