TM 11-7025-210-23
4-42. ADJUST STROBE DETECTOR ASSEMBLY (CONT)
9.
If not, loosen screws and do the following:
If time to leading pulse edge is too long, move strobe
detector toward rear of printer
If time to leading pulse edge is too short, move
strobe detector toward front of printer
10.
When pulse timing is properly adjusted, tighten screws
and recheck pulse timing.
11.
Disconnect oscilloscope leads. Remove tape from paper
out switch.
12.
Close up line printer (para 4-18).
13.
On control panel, press TEST button.
If paper handling is
still
faulty
continue
troubleshooting (table 4-3)
4-98
