TM 11-7025-210-23
4-39. REMOVE/REPLACE JACKSHAFT BEARINGS (CONT)
3.
Hold bearing puller bolt steady with hex alien wrench.
4.
Turn bearing puller block with adjusting wrench until
bearing fits tightly in housing.
CAUTION
Thread locking compound must set for 30
minutes before testing or operating printer.
5.
6.
Coat outside surface of bearing lightly with thread locking
compound.
7.
Push bearing a short distance into bearing housing.
8.
Hold bearing puller bolt steady with Allen wrench.
9.
Turn bearing puller block with adjusting wrench until
bearing fits tightly in housing.
4-89