TM 5-3610-293-13&P
4-12.
ISLATROL CONTROL BOX ASSEMBLY. - Continued
b. Replace.
(1)
Remove screws (5) securing wires (2) to line terminal board (3). Tag wires for later reference.
(2)
Remove screws (6) securing wires (2) to load terminal board (4). Tag wires for later reference.
(3)
Loosen grounding lugs (7) and disconnect ground wires.
(4)
Loosen nuts (8) on load and line cable conduits and pull cables out of islatrol control box (9).
(5)
Remove screws (10), lockwashers (11), flat washers (12), and islatrol control box.
(6)
Install replacement islatrol control box (9) and secure with flat washers (12), lockwashers (11), and screws (10).
(7)
Install load and line cable conduits and tighten nut (8).
(8)
Connect ground wires to grounding lug (7).
(9)
Install wires (2) on load terminal board (4) and secure with screws (6). Remove wire tags.
(10)
Install wires (2) on line terminal board (3) and secure with screws (5). Remove wire tags.
(11)
Close control box door cover (1).
(12)
Place printing press circuit breaker on power distribution panel in ON position.
(13)
Operate printing press.
4-23
