TM 11-6730-235-35
y. Remove thermal switch 53 (27) from the
b. Place the shaft end of the end plate (7) so
lamp housing (34).
that the shaft passes through the spring (8) and the
stud of the bracket (9).
z. Remove the two screws (28) and the two
c. Secure the end plate (7) and the spring (8) to
nuts (29) that secure the lamp mounting bracket
the bracket (9) using screw (6).
(33) to the lamp housing (34).
d. Slide the washer (4) over the shaft end of the
aa. Remove the lamp mounting bracket (33)
end plate (5).
and the lampholder (32) from the lamp housing
(34).
e. Pass the shaft of the end plate (5) with the
washer (4) on it through the free stud of the
ab. Remove the two screws (30) and the two
nuts (31) that secure the lampholder (32) to the
bracket (9) from the interior of the bracket.
lamp mounting bracket (33).
f'. Slide the crank (3) over the shaft of the end
ac. Separate the lampholder (32) from the lamp
plate (5).
mounting bracket (34).
g. Insert the screw (2) through the crank (3)
and tighten the screw to secure the end plate (5) to
ad. Remove the electrical caps (35) from the
the bracket (9).
wiring harness (36).
ae. Remove the wiring harness (36) from the
h. Grasp the spool (1) and place the keyway at
case (46).
one end of the spool over the key on the end plate
(7).
af. Remove the two nuts (37) that secure the
motor bracket (41) to the case (46).
i. Push the end plate (7) toward the bracket (9)
with the spool (1) so that the spring (8) is
ag. Remove the motor bracket (42) and the
compressed.
motor (41) from the case (46).
j. Align the free end of the spool (1) with the
ah. Remove the two screws (38), two washers
keyway on the other end plate (5) of the roll
(39), and the two nuts (40) that secure the motor
attachment.
(41) to the motor bracket (42).
NOTE
If the roll attachment is being reassembled
ai. Separate the motor (41) from the motor
for shipment or storage, insert the thumb-
bracket (42).
screws that are used to attach the roll
attachment to the case assembly (fig. 3-2)
aj. Pry the spring clip off the shaft of the motor
in the applicable holes on the bracket and
(41) and slide the fan (43) off the shaft of the
secure the thumbscrews with wing nuts.
motor (41).
3-18. Reassembly of Case Assembly
ak. Remove the four screws (44) that secure the
four rubber bumpers (45) to the case (46).
a. Install the four rubber feet (45) on the case
al. Remove the four rubber bumpers (45) from
(46) with the four screws (44).
the case (46).
b. Slide the fan (33) onto the shaft of motor B1
3-17. Reassembly of Roll Attachment
(41) and secure the fan on the shaft with the spring
clip provided.
a. Slide the end of spring (8) that has a
wider diameter over that stud of bracket (9)
c. Using the two screws (38), the two washers
that is mounted on the interior side of the
(39), and the two nuts (40) secure motor B1 (41)
bracket.
to the motor bracket (42).
3-10
