TM 11-5730-235-35
1
Spool A7MP1
2
Screw A7MP2HL
3
Crank A7MP2
4
Washer (p/o A7MP2)
5
End plate A7MP3
6
Screw A7MP4H1
7
End plate A7MP7
8
Spring A7MP5
9
Bracket A7MP6
Figure 3-3. Roll attachment, exploded view.
i. Remove ON-OFF switch S2 (7) from the case
g. Swing the sections of the fresnel lens holder
(10) open and slide the fresnel lens (9) out.
(46).
j. Remove the screw (8) that secures the green
h. Remove the two nuts (11) that secure the fres-
ground leads from convenience outlet J1 (9) and
nel catch (12) to the under side of the top plate (13).
the power cord (11) to the clip support bracket on
the case (46).
3-16. Disassembly of Case Assembly
k. Press the upper and lower metal spring clips
a. Remove the two screws (1) that secure the
on convenience outlet J1 (9) toward the body of
interlock switch cover (2) to the case (45).
the convenience outlet and push the convenience
outlet out of the case (46).
b. Remove the nut (3) from interlock arm stud
on the case (46).
l. Remove the strain relief bushing (10).
c. Lift interlock arm (4) off the interlock arm
m. Pull the lead of the power cord (11) through
stud of the case (46).
the hole in the case (46).
d. Slide the lugs of the electrical leads of the
n. Remove the power cord (11) from the case
wiring harness (36) off the terminals of the
(46).
projection lampholder (32), thermal switch S3
(27), and interlock switch S1 (5).
o. Remove the four screws (12), four washers
(13), and four nuts (14) that secure the lamp
e. Push interlock switch S1 (5) through the hole
housing mounting straps (15) to the case (46).
in the interlock support bracket on the case (45).
p. Remove the two lamp housing mounting
f. Loosen the screws securing the electrical leads
straps (15).
of the wiring harness (36) to ON-OFF switch S2
(7) and convenience outlet J1 (9).
q. Lift the lamp housing assembly (15 through
34) from the case (46).
g. Lay the wiring harness (36) on bottom of the
case (46) outside the lamp housing (34).
r. Remove the eight adjusting washers (16) and
twelve insulating beads (17) that are attaching
h. Remove the two screws (6) that secure
hardware for the projection lamp housing (34).
ON-OFF switch S2 (7) to the case (46).
3-7
