TM 11-6720-239-35
DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT
MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LIST
INTRODUCTION
Section 1.
Code
Explanation
B-1. Scope
P 2--Repair parts which are procured and
This appendix lists repair parts and special tools
required for the performance of direct support,
cause the combat or military essen-
general support, and depot maintenance of the
tiality of the end item dictates that a
KS-101A.
minimum quantity be available in the
B-2. General
supply system.
This Repair Parts and Special Tools List is di-
P 9--Assigned to items which are NSA de-
vided into the following sections:
sign controlled: unique repair parts,
special tools, test, measuring and diag-
a. Repair Parts--Section II. A list of repair
nostic equipment, which are stocked
parts authorized for the performance of mainte-
and suppled by the Army COMSEC
nance at the direct support, general support, and
logistic system, and which are not sub-
depot level.
ject to the provisions of AR 380-41.
b. Special Tools, Test and Support Equipment
P 10--Assigned to items which are NSA de-
--Section III. Not applicable.
sign controlled: special tools, test,
c. Index--Federal Stock Number Cross-Refer-
measuring and diagnostic equipment
ence to Figure and Item Number or Reference
for COMSEC support, which are ac-
Designation Index--Section IV. A list of Federal
countable under the provisions of AR
stock numbers in ascending numerical sequence
380-41, and which are stocked and
followed by a list of reference numbers in ascend-
supplied by the Army COMSEC logis-
ing alpha-numeric sequence, cross-referenced to
tic system.
illustration figure number and reference desig-
M --Repair parts which are not procured or
nation.
stocked, but have to be manufactured
in indicated maintenance levels.
d. Index--Reference Designation Cross-Refer-
A --Assemblies which are not procured or
ence to Page Numbers--Section V. A list of refer-
stocked as such, but are made up of
ence designations cross-referenced to page num-
two or more units. Such component
ber.
units carry individual stock numbers
and descriptions, are procured and
B-3. Explanation of Columns
stocked separately, and can be assem-
The following provides an explanation of columns
bled to form the required assembly at
in the tabular lists.
indicated maintenance categories.
a. Source, Maintenance, and Recoverability
X --Parts and assemblies which are not pro-
Codes (SMR), Column 1.
cured or stocked and the mortality of
(1) Source code indicates the selection status
which is below that of the applicable
and source for the listed item. Source codes are--
end item or component. The failure of
such part or assembly should result in
Code
Explanation
P
-Repair parts which are stocked in or
retirement of the end item from the
supplied from the GSA/DSA, or Army
supply system.
supply system, and authorized for use
X 1--Repair parts which are not procured or
at indicated maintenance categories.
stocked. The requirement for such