11-6720-239-35
DEPOT OVERHAUL STANDARDS
Quantity
required
Federal stock No.
Equipment
Standards
1 ea.
Part of Camera Set
Flashgun
1 box
----------------------
M3 flash bulbs
Camera Set, Still Picture KS101A, must be
1 ea.
6750-775-8835
Film/pack
tested thoroughly after rebuilding or repair to in-
1 ea.
----------------------
Light source probe
1 ea.
----------------------
Test stand
sure that it meets adequate performance require-
1 ea.
----------------------
Light source
ments for return to stock and reissue. Use the
1 ea.
----------------------
Phototube/camera
tests described in this chapter to measure the per-
adapter
1 ea.
Polaroid Part No. 1P39
Phototube, type
formance of the repaired camera equipment. It is
1P39
mandatory that repaired equipment that is to be
1 ea.
6625-228-2201
reissued, or returned to stock for reissue, meet all
Tektronic type
502A
of the performance standards given in this chap-
1 ea.
5950-235-2086
110 vac variable
ter.
1 ea.
----------------------
Eastman Kodak
target
1 ea.
4-2. Applicable References
Rear lens adapter
----------------------
unit
a. Repair Standards. Applicable procedures of
1 ea.
10 VDC stepdown
----------------------
the Signal Corps depots performing this test and
1 ea.
----------------------
90-volt battery
its general standards for repaired Signal equip-
1 ea.
Polaroid Part No. 1493
Lamp, type 1493
ment form a part of the requirements for testing
or 1594
or 1594
1 ea.
6697-641-5083
Light meter (50 to
this equipment.
800-foot candles)
b. Technical Publications. The technical publi-
4-4. General Operational Test for Camera
cations listed below are applicable as indicated.
Set KS-101A
Equipment and subject
Publication
a. Visually examine the overall appearance of
TM 11-6720-239-12
Operator and Organizational Main-
the camera body. Note any obvious defects.
tenance Manual Including Repair
b. Extend the bellows and look for obvious de-
Parts and Special Tool Lists: Camera
fects.
Set, Still Picture KS-101A.
Field and Depot Maintenance Manual: TM 11-6720-211-35
c. Examine batteries B1 and B2 for leakage or
Camera Set, Still Picture KS-17A.
corrosion. Replace defective batteries.
d. Cock and trip the shutter. Note obvious de-
c. Modification Work Orders. Perform the work
fects in shutter locking and tripping mechanism.
specified by Modification Work Orders pertaining
e. Look through the lens and at the same time
to this equipment before making the test specified.
observe the operation of the opening and closing
DA Pam 3107 lists all available MWO'S.
blades.
f. Inspect the rollers as follows:
(1) Open the rear door.
4-3. Test Facilities Required
(2) Lift the roll latch and swing out the roll-
The following test equipment, or suitable equiva-
ers.
lents, will be used in determining compliance with
(3) Inspect rollers for damage, misalign-
ment, or dirt.
the requirements of these inspection standards.
