TM 11-7025-210-23
4-56. ADJUST MAGNETIC BELT GUIDE AND REBOUND BAR (CONT)
9. Using feeler gauge, set clearance gap of 0.039
0.003 inch (1.0 + 0.08 mm), as shown, between
pulley and alignment gauge.
10. Snug down large slotted screw. 11. Go to left end of
magnetic belt guide. Repeat steps 8-9.
12. Tighten large slotted screw at each end of magnetic
belt guide.
13. Locate rebound bar, attached to top rear area of
hammerbank assembly.
4-138
