TM 11-7025-210-23
4-59. REMOVE/REPLACE DEFECTIVE TYPE FINGER (CONT)
CAUTION
Use procedure in paragraph 4-60 to remove
reference fingers. Do not use the procedure
in this paragraph. Damage to finger and belt
will result.
4. Using finger removal pliers, grasp defective type
finger firmly near top of belt, as shown.
5. Slowly pull finger straight up until free from print
belt.
Replace
1. Using finger removal pliers, grasp type finger near
tab.
2. Slowly push finger into print belt until tab enters top
of belt, as shown. Make sure character faces outside
of belt.
3. Close up line printer (para 4-18, steps 4-8).
4. On control panel, press TEST button.
4-146
