TM 11-7025-210-23
4.
Move pulley up until belt is snug.
5.
Using belt tension gauge, measure belt tension.
If tension is 4 ounces pressure with 1/4 in.
deflection, go to step 7
If tension is not 4 ounces pressure with 1/4
in. deflection, go to step 6
6.
Loosen screw. Move pulley up or down.
Measure tension. Repeat until tension is 4
ounces pressure with 1/4 in. deflection. Tighten
screw.
7.
Turn motor drive pulley counter-clockwise.
Make sure pulleys turn freely. If pulleys don't
turn freely, go back to Replace, step 1.
8.
Replace plate.
9.
Tighten screws.
10.
Close up line printer (para 4-18, steps 3-8).
11.
On control panel, press TEST button.
4-69
