C 1, TM 11-6720-248-12
be photographed in a relatively long time period. The
additional, fully charged battery trays. If the condition is
strobe assembly is capable of approximately 80 flashes
anticipated, the spare battery trays are charged overnight
before it is necessary to recharge the batteries.
in the external charger and usually will provide 8 hours of
heavy operation.
a. Place the power switch to B (Model 600) or to
a. Insert battery trays into charger until they latch in
ON (Model 700).
b. The neon indicators will light when the strobe
place.
assemblies are ready to be fired.
b. Connect charger power cord to 115 volts ac, 50
to 60 Hz source.
3-5.1. External Battery Charger
When battery operation is required in locations with ac
c. If batteries are quite low, rotate timer knob to
power unavailable at the photo site, the external battery
maximum time, otherwise set timer to charge time
charger is used to provide four
required to bring batteries up to full charge.
d. Red lamp glows until time has elapsed, the time
automatically turns off when time has elapsed.
Figure 3-4.1. Strobe assembly, rear view, model 700.
3-4
