TM 11-6720-248-12
C1
Figure 3-2. Camera assembly, rear view
f. Attach the dual strobe support arm and strobe
and clamp assemblies (para 2-4b).
g. Connect the shutter and flash cords (para 2-5a
and b).
3-4. Ac Operation
Figure 3-3. Camera opened.
The strobe assembly is used in the ac operation mode
when a, large number of subjects are to be
photographed in a relatively short period of time.
a. Insert one end of each power cord into the
receptacle provided in each strobe assembly.
b. Plug the opposite end of each power cord into a
power outlet source of 115 volts ac, 50 to 60 Hz.
c. Place the power switch to A (Model 600, fig.3-4)
or ON (Model 700, fig.3-4.l).
d. The neon indicators may not light during ac
operation; full output of the strobe assembly will be
realized if 25 seconds is allowed from the time the power
switch is positioned to A or ON until the strobe assembly
is operated.
3-5. Battery Operation
The strobe assembly is used in the battery operation
mode when a small number of subjects are to
Figure 3-4. Strobe assembly rear view,
model 600.
3-3
