(3) To replace the lamp socket, reverse the disassembly instruc-
tions given in subparagraphs (1) and (2) above.
(1) To remove the male receptacle from the front panel of the
housing, remove the two screws (24, fig. 5) and nuts that
hold the receptacle to the panel and lift the receptacle out
as far as the wires will permit. Loosen the screws that hold
the wire terminals to the receptacle. Remove the receptacle.
(2) To replace the male receptacle, reverse the disassembly in-
structions given in subparagraph (1) above.
(1) To remove the ON-OFF switch from the front panel of the
housing, remove the two screws (13, fig. 5) that hold the
switch to the panel. The terminal screws will then be acces-
s i b l e through the front hand-hole. Loosen the terminal
screws and release the wires. Remove the switch.
(2) To replace the ON-OFF switch, reverse the disassembly in-
structions given in subparagraph (1) above.
k. Fuses and Fuse Holders (figs. 5 and 15).
(1) To remove the fuses. turn the fuse cap (14, fig. 5) counter-
clockwise; the fuse will come out when the cap is released.
(2) To remove the fuse holders, first unsolder the two wires, then
unscrew the hexagonal nut behind the panel; withdraw the
fuse holders from the panel.
(3) To replace the fuses and fuse holders, reverse the disassembly
instructions in subparagraphs (1) and (2) above.
l. Elevating Legs (figs. 5
and 15) .
(1) To remove an elevating leg (11, fig, 5) and leg tension
spring, first loosen the clamping screw (10, fig. 5) on the
front of the panel which clamps the leg in position. Adjust
the leg so that it protrudes from the housing to about half
the distance of its travel. Tighten the clamping screw.
(2) Use a small hammer and drift pin and carefully tap the split
pin that holds the leg in the housing until the pin is forced
out of the hole in the leg. Loosen the clamping screw and
slide the leg out of the housing.
(3) Pry the leg tension spring out of the U-shaped hole in the
housing, and remove it from the housing.
(4) To replace the elevating leg and spring, reverse the dis-
assembly instructions given in subparagraphs (1) through
(3) above.
m. Glide (fig. 15) . To
remove a
rear glide, unscrew the
nut located
inside the channel cross brace on the housing base, and pull the glide
from the base. To replace the glide, slide the threaded glide shaft
42
--.