Figure 7. Projection lamp installed.
f. For the PH-637/PFP, raise the shelf at the front of the housing
until it snaps into the horizontal position. For both the PH-637/PFP
and the PH437A/PFP, raise the shelf on the left-hand side of the
housing until the shelf support swings out to hold the shelf in place.
g. If the cellophane material is needed for projection purposes on
the PH-637/PFP, secure the roll attachments to the housing with the
captive screws provided; locate the take-up unit on the left side of
the housing and the supply unit on the right side (par. 16).
h. Plug the female connector on the end of the power cable into the
receptacle connector on the front of the projector housing, and plug
the male connector into a 115- to 120-volt, 60-cycle, ac power source.
Section II. OPERATION UNDER USUAL CONDITIONS
12. Controls
This paragraph describes, locates, and furnishes the operator with
all the information pertaining to the various controls for proper
operation of the equipment. Do not attempt the operation of this
equipment until the use of all operating controls is understood fully.
15
TAGO 4738B
