TM 10-3610-202-14
(2)
Drill out the blind rivets securing the sink
shield to the headliner counter and shelter wall.
(3)
Slide the sink shield to the left and
remove.
c.
Installation To install the sink shield proceed
as follows:
(1)
Using heavy paper, construct a mounting
hole location template by placing the paper on the
removed sink shield and marking mounting holes.
(2)
Using the template as a guide, drill
mounting holes in the replacement sink shield.
(3)
Position the sink shield on the headliner
counter with rear shield positioned behind the faucet
bracket.
(4)
Secure the sink shield with blind rivets.
(5)
Position the faucet bracket on the sink
shield and install attaching screws.
Section XVIII. MAINTENANCE OF SINK ASSEMBLY
4-40. General. The sink assembly is recessed in
forward section of headliner counter directly below water
tank. The sink is used to contain and/or eliminate
discarded water and other liquids used in conjunction
with the operation of the shelter. The sink assembly
also contains ai plug and chain which are secured to the
wall directly above the sink. (See fig. 4-26.)
4-41. Sink Assembly.
a.
Inspection Inspect the sink assembly as
follows:
(1)
Inspect sink for signs of rust and clogging.
(2)
Inspect plug and chain for signs of wear or
damage.
(3)
Inspect sink for damage which could
cause leakage into area of counter below sink.
(4)
Report any defects to direct and general
support maintenance personnel.
Section XIX. MAINTENANCE OF AIR CONDITIONER AND AIR INTAKE FILTER
4-42. General.
A removable air filter, installed in the air
conditioner intake louver permits filtered outside air to
enter the air conditioner.
4-43. Air Conditioner Air Intake Filter.
a.
Removal To inspect the air filter, remove as
follows:
(1)
Remove the eight screws attaching the air
conditioner air intake louver to the right exterior shelter
wall. (See fig. 4-25.)
(2)
Remove the louver and gasket.
(3)
Remove the filter and two grills from the
louver frame.
4-45
