TM 10-3610-203-14
CHAPTER 9
REPAIR OF STOOL HOLDDOWN ASSEMBLY
9-1. General
The stool holddown assembly secures the stool to the right shelter wall just forward of the bench assembly and aft of
the paper storage cabinet, by means of a retaining strap and two fastener loops which are attached to the wall of the
shelter.
9-2. Stool Assembly Holddown
a. Inspection. Inspection procedures for the stool holddown assembly are as follows:
(1) Inspect the fastener loops and the screws that attach them to the shelter wall for security and condition. Remove
and replace as required.
(2) Inspect the retaining strap and the retaining strap buckle for security and condition. Remove and replace as
required.
b. Removal. Remove the stool holddown assembly as follows:
(1) Unlatch the retaining strap and remove the stool assembly. (See fig. 9-1).
TS 3610-203-14/9-1
Figure 9-1. Stool Holddown Assembly, Removal and Installation.
9-1