TM 5-3610-294-13&P
2-14. PREPARATION FOR MOVEMENT. -Continued
g.
Secure all cabinet and storage compartment doors.
h.
Unplug electrical cords of the ceiling fluorescent light assemblies in the expanded sections of the shelter.
Remove light assemblies by depressing the safety release button, sliding the light assemblies in their overhead
storage locations in the center section of the shelter, secure with red safety release brackets, and secure their
electrical cords in their storage clips.
NOTE
Each equipment item to be stowed in the shelter center section is marked with a colored dot. There is a
corresponding colored dot on the shelter ceiling and floors. Items are to be stored in the order listed below by
matching the colored dot on the equipment with its matching colored dot in the floor and ceiling of the shelter
center section.
i
.Refer to Figure 2-16 and stow equipment in the following order.
(1)
Roll up floor mat and place in storage location, and place cover on paper cutter.
(2)
Place the folding chair with the white dot in position over the white dot on the shelter floor.
(3)
Place the office cabinet with yellow dot in position over the yellow dot on the shelter floor.
(4)
Place the two-shelf table with black dot on top of the paper storage rack with green dot, and under the
black dot in the shelter ceiling.
(5)
Place paper storage rack with green dot in position over green dot on shelter floor.
2-29
