TM 5-3610-293-13&P
4-22. SINK ASSEMBLY. - Continued
(3)
Tag and disconnect terminal wires (2) from water level monitor (3).
(4) Remove nuts (4), lockwashers (5), flat washers (6), and screws (7) holding water level monitor in place.
(5) Remove water level monitor (3).
(6) Place new water level monitor (3) in place.
(7) Install screws (7), flat washers (6), lockwashers (5), and nuts (4) holding water level monitor (3) in place.
(8) Connect terminal wires (2) to water level monitor (3) and remove tags.
(9) Close rear door (1).
(10) Turn on power and test operation.
j.
Repair by replacing Fresh Water or Grey Water Tank Level Probe. (Figure 4-26.)
(1)
Drain water tank (1). Refer to paragraph 2-14.
WARNING
Disconnect power to the sink assembly before opening rear door. DEATH on
contact may result if power is not disconnected.
NOTE
Hot water tank must be removed before removing gray water tank level probe.
(See h. above.)
(2)
Open rear door (2).
(3)
Loosen top nut (3) on water tank level probe (5).
(4)
Disconnect terminal wire (4) to water tank level probe (5).
(5)
Loosen bottom nut (6) on water tank level probe (5).
4-66
