TM 5-3610-293-13&P
4-21. FOLDING TABLES.- Continued
(3)
Remove screws (13) and hinge (14).
(4)
Position two parts of replacement table top (11) on flat surface and secure
hinge (14) with screws (13).
(5)
Install legs (5). (See b. above.)
(6)
Position folding table on wall bracket (15) and secure with screws (12).
4-22. SINK ASSEMBLY.
This task covers: a. Replace b. Repair
INITIAL SETUP
Tools
General Mechanics Automotive Tool Kit, Appendix B
Pipe Wrench, Appendix B
Materials
Tape, thread scal, MIL-T-27730A
RTV Sealing Compound
Petroleum Jelly
Tools
General Mechanics Automotive Tool Kit, Appendix B
a. Replace. (Figure 4-18.)
(1)
Place sink assembly circuit breaker in Power Distribution Panel to OFF
position.
(2)
Remove sink assembly power connector (1) from wall socket.
(3)
Disconnect water supply line (2) and drain line (3).
(4)
Lower sink transport wheels using transporter knobs (4) and remove sink
assembly from shelter.
(5)
Place new sink assembly in shelter.
NOTE
If new sink assembly does not have transporter assemblies attached, refer to
paragraph 4-22.o.
4-50
