TM 11-6730-235-12
tioned, see if it has been changed by a modification work
cord to reach without applying any tension to the
order (MWO). If modified, the MWO number is marked
projector.
on the projector.
c. Locate the projector at a distance (from 4 to 25 feet)
from the projection surface that produces a projected
2-3.
Installation
image large enough to be seen by the full class or
Installation of the projector set consists of setting it up for
audience.
operation.
d. Do not obstruct the louvers at the front and rear ends
a. Place the projector on a surface that is at least 24
of the case assembly; a free flow of air must be
inches wide and 30 inches deep.
maintained.
b. The line cord is 15 feet long; locate the projector
close enough to a 110-volt, 60-Hertz (Hz) power
e. Make sure that no articles on the projector mounting
convenience outlet to permit the line
surface obstruct the holes in the bottom
Figure 2-2. Top plate assembly locked in open position.
2-3
