CHAPTER 7
S H I P M E N T AND LIMITED STORAGE AND
D E M O L I T I O N TO PREVENT ENEMY USE
Section I. SHIPMENT AND LIMITED STORAGE
54. Disassembly for Storage or Shipment
When the equipment is to be stored or reshipped, proceed as follows:
a. Place the dust cap on the objective lens and remove the lens
from the lens mount.
b. Remove the projection lamp from the socket, pushing down
gently on the lamp and griving it at 90 turn counterclockwise. Lift
the lamp out of the socket and close the shield and slide access doors
Tighten the captive screws.
c. Remove the power cord from the receptacle and form it into a
coil approximately 7 inches in diameter
55. Repackaging for Storage or Shipment
a. Place the projector and its components (fig. 2) in the carrying
case as follows:
(1) Open the four carrying case latches, and lift the case top
off the base
(2)
Place the coiled power cable in the pocket provided insided
the case top
(3)
Place the projection lamp in one of the three lamp cartons.
Place the three cartoned lamps in the compartment provided
in the base. Secure it with the strap.
(4) Place the projectionlens in the compartment provided in
the base. Secure them with the strap.
Rack the lens mount back, and place the projector on the
(5)
base shock mount. Hook the two clamps over the projector
housing base, and secure them by tighten ing the wing nuts.
Hook the retaining springs on the wing nuts
(6) Put the upper section ofvthe case inplace on the base, and
close the four latches.
48
