TM 10-3610-202-14
CHAPTER 5
DIRECT AND GENERAL SUPPORT
MAINTENANCE INSTRUCTIONS
Section I. REPAIR PARTS, SPECIAL TOOLS AND EQUIPMENT
5-1. Special Tools and Equipment.
No special tools or equipment are required by direct and
general
support
maintenance
personnel
for
the
maintenance of the editorial and photo- mechanical
shelter.
5-2. Maintenance Repair Parts.
Repair parts and equipment are listed and illustrated in
the repair parts and special tools list covering direct and
general support maintenance in TM 10-3610-202-34P.
Repair parts required for maintenance of the various
items of equipment which form a part of the shelter
system are defined in the applicable publication supplied
with each unit.
5-3. Fabricated Tools and Equipment.
No fabrication of special tools and equipment is
necessary
for
maintenance
of
the
editorial
and
photomechanical shelter.
Section II. TROUBLESHOOTING
5-4. General.
a. This
section
contains
troubleshooting
information for locating and correcting most of the
operating troubles which may develop in the editorial
and photomechanical unit of the special warfare printing
plant. Each malfunction for an individual component,
unit or system is followed by a list of tests or inspections
which will help you to deter- mine corrective actions to
take. You should perform the tests/inspections and
corrective actions in the order listed.
b. This manual cannot list all malfunctions that
may occur, nor all tests or inspections and corrective
actions. If a malfunction is not listed or is not corrected
by listed corrective actions, notify your supervisor.
5-5. Troubleshooting.
Refer to table 5-1 for troubleshooting information and
procedures
applicable
to
the
editorial
and
photomechanical shelter system and components.
Table 5.1. Troubleshooting
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
SHELTER SYSTEM COMPONENTS
1. LIGHT TABLE GEAR TRACK NOT OPERATING CORRECTLY.
Inspect gear track assembly in accordance with applicable commercial publication.
If necessary, replace defective gear track assembly in accordance with applicable commercial
publication.
Change 1 5-1
