TM 10-3610-202-14
Figure 5-12. Rear Camera Lamp Holddown Bracket
a.
Inspection.
Inspect
the
camera
lamp
holddowns as follows:
(1)
Inspect for proper security.
(2)
Inspect the straps and buckles for general
condition.
(3)
Replace as necessary.
b.
Left Lamp Holddown.
(1)
Removal Remove the left lamp holddown
as follows:
(a)
Unlatch the retaining straps and
loosen retaining stud; move lamp assembly clear.
(b)
Remove the screws that attach the
fastener loops to the shelter wall and remove the
fastener loops from the retaining straps.
(2)
Installation.
Install
the
left
lamp
holddowns as follows:
(a)
If necessary, fabricate new retaining
strap as follows:
1.
Cut appropriate length of cotton webbing to
match previously removed retaining strap.
2.
Machine sew loop ends and buckle to webbing.
3.
Cut webbing end to receive end clip and press
clip to webbing.
(b)
Install the fastener loops through
the ends of the new retaining strap and secure the
fastener loops to the shelter wall with two screws.
(c)
Position the lamp assembly and
secure with retaining straps.
c.
Right Lamp Holddowns.
(1)
Removal. Remove the right lamp
holddowns as follows:
(a)
Unlatch
the
retaining
straps
securing the right camera light to the camera light
holddown bracket. (See fig. 5-12.)
5-20
