TM 10-3610-202-14
a. Removal. Remove the film dryer as follows:
(1) Disconnect electrical connector from wall
receptacle.
(2)
Remove
attaching
wing
screws
from
underside of film dryer shelf.
(3) Remove dryer.
(4) Remove attaching screws from back of dryer
and remove deflector.
(5) Remove four mounts.
b. Installation. Install the film dryer as follows:
(1)
Remove
existing
mounts
from
the
replacement film dryer.
(2) Install mounts from removed film dryer, on
replacement film dryer.
(3) Refer to figure 5-14 and drill deflector
attachment holes in rear of dryer.
Figure 5-14. Film Dryer Deflector Installation
(4) Position deflector on back of new dryer at
same position as previously mounted on removed film
dryer.
(5) Secure deflector with four existing thread
forming screws,
(6) ,Position film dryer on film dryer shelf and
secure with four attaching wing screws.
5-15. Film Dryer Shelf.
A stainless steel film dryer shelf is mounted on the
right shelter wall immediately above the sink.
a. Removal. Remove the film dryer shelf as follows:
(1) Disconnect film dryer electrical connector from
wall receptacle.
(2) Remove film dryer attaching wing screws from
underside of film dryer shelf.
(3) Remove film dryer.
(4) Drill out blind rivets attaching film dryer shelf
to the shelter wall and backing sheet. (See fig. 5-15.)
5-22
