TM 10-3610-202-14
(b) Remove the attaching wingbolts securing the
camera light holddown bracket to the shelter floor.
(c) Remove the bracket.
(2) Installation . Install the right lamp holdowns as
follows:
(a) If necessary, fabricate new retaining strap as
follows:
1. Cut appropriate length of cotton webbing
to match previously removed retaining strap.
2. Machine sew loop ends and buckle to
webbing.
3. Cut webbing end to receive end clip and
press clip to webbing.
(b) Position the camera light holddown bracket
over the two floor fasteners and secure with attaching
wingbolts.
(c) Position the light assembly and secure with
retaining strap.
5-14. Film Dryer.
The electric film dryer is a Decco Model 1418 which
utilizes air blade drying to provide quick film drying. The
dryer is mounted on a shelf attached to the right-hand
shelter wall above the sink. The wet processed film is fed
into the dryer through a slot located in the front panel of
the unit. A series of squeegee rollers then carries the film
through the dryer passing it between a set of upper and
lower air tubes which direct the air over the surfaces of
the film. The dried film is then passed through a slot in
the rear of the dryer housing. A deflector mounted on the
rear housing then steers the film upward and back over
the top of the dryer unit to bring it within reach of the
operator. (See fig. 5-13.) Power for the dryer is obtained
through an adjacent equipment receptacle and is
controlled by means of a two-position switch on the front
of the unit.
Figure 5-13. Film Dryer and Deflector Assembly
5-21
