TM 10-3610-202-14
(7)Remove the bolts which attach the lower metal shim
at the rear of the unit and remove the shim.
(8)
Note and record wire positions on blower
motor receptacle and disconnect wires.
(9)
Remove blower motor receptacle.
(10)
Position the platemaker lower front cover
and install the attaching screws, washers and nuts.
d.
Installation. Install the replacement offset
platemaker as follows:
(1)
Remove the two nuts, which attach the
platemaker lower front cover and remove the cover.
(2)
Position the support leg to each corner of
the platemaker and install the attaching bolts, washers
and nuts.
(3)
Disconnect
blower
motor
lead
from
external receptacle.
(4)
Remove the screws which attach the
pump at the upper rear of the platemaker and remove
the pump.
(5)
Obtain measurements from defective
platemaker and using a suitable drill, drill a new pump
intake hole and pump mounting holes.
(6)
Remove the two screws which attach the
blower motor receptacle and from inside platemaker,
pull receptacle to inside of unit.
(7)
Obtain measurements from defective
platemaker and, using a suitable drill, drill mounting
holes for stainless steel duct and shims.
(8)
Position blower motor inside unit with
housing outlet pointing toward left side of unit and install
attaching screws.
(9)
Using
previously
recorded
wire
configuration, install new blower motor plug.
(10)
Position stainless steel duct and upper
and lower shims at rear of unit and install attaching
screws and bolts.
(11)
Connect blower motor lead to replaced
blower motor plug.
(12)
Carefully move the platemaker into the
shelter and position over the shelter floor mounting
points.
(13)
Install the four bolts and washers which
attach the platemaker to the mounting points.
(14)
Position the platemaker lower front and
install the two attaching nuts.
(15)
Check that all switches are in off or
neutral position and connect platemaker power cord to
electrical receptacle.
5-9. Light Table Assembly.
A light table assembly, located on the left side of the
shelter next to the platemaker, is supplied for tracing,
artwork, and opaquing negatives. The light table
consists of a metal shell which encases the fluorescent
lamp mechanism. The light table glass forms a part of
the lid. A straightedge assembly with integral rotary
gears is mounted on two gear tracks, one on each side
of the glass. (See fig. 5-5.)
5-12
