TM 10-3610-202-14
(3)Remove the four bolts and washers which attach the
platemaker to the shelter floor mounting points.
(4)
Carefully move the platemaker away from
the shelter wall so as to clear the shock mounts, file
cabinet, and light table. Remove the platemaker from
the shelter.
(5)
Remove the bolts, washers and nuts
which attach the support leg to each corner of the
platemaker and remove the legs.
(6)
Remove the screws which attach the
stainless steel tray type duct at the rear of the
platemaker and remove the duct. (See fig. 5-4.)
Figure 5-4. Duct and Blower Motor, Removal and lllustration
5-11
