TM 5-3610-295-13&P-2
SECTION III. OPERATION UNDER USUAL CONDITIONS
2-8. ASSEMBLY AND PREPARATION FOR USE.
a.
Site Selection.
(1)
Select a site where ground is firm, dry and has good drainage.
(2)
Vehicle containing shelter must be parked on level ground.
(3)
When used with the Modular Printing System (MPS), refer to
TM 5-3610-294-13&P, Module C, Finishing Section.
b. Unloading Shelter. Refer to TM 10-5411-207-14
c. Grounding the Shelter. The Press Shelter is grounded to the power source through
the main power cable. Be sure the power source is properly grounded.
d. Unpacking.
(1)
Use care when unpacking any of the items of the Press Shelter.
(2)
Remove tape seals which secure doors and other apertures.
(3)
Remove tiedown straps which secure smaller items of equipment inside
shelter.
(4) Remove paper or other packing material from cables, etc.
WARNING
DEATH or serious injury could result by repeated and/or
prolonged breathing or skin contact with drycleaning solvent P-D-
680. Use in a well-ventilated area. Do not use near open flame or
in excessive heat. The flash point of this solvent is 100°F - 138°F
(38°C - 59°C).
(5) Remove preservative compound from all unfinished metal surfaces with drycleaning
solvent (19, Appendix E).
e. Checking Unpackaged Equipment.
(1) Inspect the equipment for damage incurred during shipment. If the equipment has been damaged,
report the damage on DD Form 6, Packaging Improvement Report.
2-11
