TM 5-3610-295-13&P-1
4-29.
PHOTOTYPESETTER ASSEMBLY. - Continued
d. Replace Monitor Assembly. (See Figure 4-34.)
(1) Remove thumbscrews (1) from monitor top bracket (2).
(2) Remove wingnut (3), flat washer (4), and lock nut (5).
(3) Carefully rotate monitor (6) clockwise 900.
(4) Remove screws (7), and monitor top bracket (2).
(5) Remove cable (8) from rear of controller.
(6) Lift monitor (6) from table and lay on side.
(7) Remove countersunk screws (9) and monitor mounting plate (10) from monitor (6).
(8) Position monitor mounting plate (10) over holes in base of replacement monitor (6) and install countersunk
screws (9).
(9) Position replacement monitor (6), and connect cable (8) to rear of controller.
(10) Carefully rotate monitor (6) clockwise 900 and install monitor top bracket (2) and screws (7).
(11) Rotate monitor (6) counterclockwise 900 and install lock nut (5), flat washer (4), and wingnut (3).
(12) Install thumbscrews (1).
4-85
