TM 5-3610-295-13&P-1
SECTION III. OPERATOR MAINTENANCE PROCEDURES
3-4. GENERAL. Operator maintenance is limited to servicing and secondary type maintenance on the commercial
equipment. These service and maintenance procedures are outlined in the commercial publications supplied with the
various items of equipment. This section contains those procedures not covered by commercial publications and
deemed operator's responsibility. You should call organizational maintenance for any other maintenance requirements
on the editorial shelter.
3-5. SAFELIGHT ASSEMBLY.
This task covers:
a.
Inspect
b.
Replace
INITIAL SETUP
Tools
None
Material
Fluorescent light bulbs
a. Inspect (See Figure 3-1.)
(1) Inspect light fixture for broken bulb.
(2) Place light switch circuit breaker in ON position and check light for operation.
b. Replace. (See Figure 3-1.)
(1) Remove lamp (1).
(2) Install lamp (1) in light fixtures by aligning lamp contacts with slots in both ends of lamp fixture and
turning one-quarter turn clockwise.
3-7/(3-8 Blank)
