TM
11-7025-232-10
2-8. INSTALL/REMOVE PAPER (CONT)
19. Press PAPER STEP switch on control
p a n e l until paper enters paper
support, as shown.
20. Press TOP OF FORM switch on control
panel.
2 1 . Position paper release lever so that
r e d marker is visible.
22. Open band cover.
23. Locate 6 LPI and 8 LPI top of form
i n d e x markings on left and right
sides of hammer bank mask.
24. Check the way top of form is set:
Top of form is the same as the
f i r s t p r i n t line on the paper form
the exampl e shown, the desired
In
f i r s t p r i n t l i n e is line six, so
t h e p e r f o r a t i o n is set at number
six
2-14
