TM 11-7025-210-10
3-6. REMOVE/REPLACE RE-INKER (CONT)
Replace
CAUTION
The re-inker should be used only when print
becomes light
Do not over-ink.
NOTE
The ribbon cartridge has a built-in wrench to
help you unscrew cap. It is on the bottom of
the ribbon cartridge under the re-inker slot,
as shown.
1. Unscrew cap on replacement re-inker. Store for future
use.
2. Hold tab on top of re-inker.
3. Tilt bottom of re-inker inward. Insert. Re-inker snaps into
place.
4. Close cover.
3-8
