TM 11-6730-204-34P
INTRODUCTION
1. Scope
Definition
Code
This manual lists spares and repair parts; special
PA - Item procured and stocked for anticipate or
known usage.
tools; special test, measurement, and diagnostic
XD - A support item that is not stocked. When
equipment (TMDE), and other special support
required, item will be procured through
equipment required for performance of direct
normal supply channels.
support and general support maintenance of the
NOTE
AP-5(1) and AP-5(2). It authorizes the
Cannibalization or salvage may be used as
requisitioning and issue of spares and repair parts
a source of supply for any items source
as indicated by the source and maintenance codes.
coded above except those coded XA and
2. General
aircraft support items as restricted by AR
This Repair Parts and Special Tools List is divided
700-42.
into the following sections:
(2) Maintenance code. Maintenance codes are
assigned to indicate the levels of maintenance
and repair parts authorized for use in the per-
authorized to USE and REPAIR support items.
formance of maintenance. The list also includes
The maintenance codes are entered in the third and
parts which must be removed for replacement of
fourth positions of the Uniform SMR Code format
the authorized parts. Parts lists are composed of
as follows:
functional groups in numeric sequence, with the
(a) The maintenance code entered in the
parts in each group listed in figure and item
third position will indicate the lowest maintenance
number sequence.
level authorized to remove, replace, and use the
b. Section III. Special Tools List. Not ap-
support item. The maintenance code entered in the
plicable.
third position will indicate one of the following
c. Section IV. National Stock Number and Part
levels of maintenance:
Number Index. A list, in National item iden-
tification number (NIIN) sequence, of all National
Applcation/Explanation
Code
stock numbers (NSN) appearing in the listings,
O - Support item is removed, replaced, used at the
followed by a list, in alphameric sequence, of all
organizational level.
part numbers appearing in the listings. National
H - Support item is removed, replaced, used at the
stock numbers and part numbers are cross-
general support level.
referenced to each illustration figure and item
(b) The maintinance code entered in the
number appearance.
fourth position indicates whether the item is to be
repaired and identifies the lowest maintenance level
3. Explanation of Columns
with the capability to perform complete repair (i.e.,
a. Illustration. This column is divided as
all authorized maintenance functions). This
follows:
poistion will contain one of the following main-
t h e figure
(1) Figure
number. Indicates
tenance codes:
number of the frustration on which the item is
shown.
Application/Explanation
Code
(2) Item number. The number used to
H - The lowest maintenance level capable of
identify item called out in the illustration.
complete repair of the support item is the
b. Source, Maintenance, and Recoverability
general support level.
(SMR) Codes.
Z - Nonreparable. No repair is authorized.
(1) Source code. Source codes indicate the
(3) Recoverability code. Recoverability codes
manner of acquiring support items for main-
are assigned to support items to indicate the
tenance, repair, or overhaul of end items. Source
disposition action on unserviceable items. The
codes are entered in the first and second positions
recoverability code is entered in the fifth position
of the Uniform SMR Code format as follows:
of the Uniform SMR Code format as follows:
