TM 10-3610-203-14
Section III. GENERAL MAINTENANCE
5-6. General
The instructions contained in this chapter are for the use of direct and general support personnel responsible for
maintenance of the press shelter unit of the special warfare printing plant.
5-7. General Maintenance Procedures
Procedures for general repair and maintenance are defined where they occur during the performance of maintenance
activity covered by the various sections and paragraphs of this chapter. Maintenance procedures for the items of
equipment which form a part of the shelter system are included in the various commercial manuals supplied with the
equipment. Refer to TB 750-240 for maintenance and repair procedures pertaining to the shelter itself.
Section IV. REMOVAL AND INSTALLATION OF MAJOR COMPONENTS AND ASSEMBLIES
5-8. Duplicating Machine and Stacker
a.
General. An Addressograph Multigraph Model 1250 Multilith Offset duplicating machine is floor mounted along
the left wall of the shelter. The duplicating machine, which is of the single lever control type, incorporates an integral
Model 1210 receding stacker which is used to speed the drying of ink and to provide mechanical jogging of duplicated
material. Ink drying is accomplished by means of an infrared drying lamp. The press is capable of high speed
production of clear, quality impressions of a duplicating master.
b.
Removal.
(1)
Disconnect the duplicating machine power cord from the equipment receptacle.
(2)
Remove the color press attachment as follows:
(a)
Remove the ink and water fountain control knobs. (See fig. 5-2.)
5-7
