TM 10-3610-203-14
(c)
Remove screws and clamps that secure tubing to shelter wall and front panel.
(d)
Disconnect water supply line at connectors and remove tubing.
(e)
Close humidifier drain valve.
(3)
Installation.
(a)
Position tubing and connect water supply line at connectors.
(b)
Position tubing on shelter wall and secure with clamps and screws.
NOTE
Open previously closed valve at bottom of tank to allow waterflow to humidifier before placing unit in
operation
(c)
If replacement of tubing is required, bend and cut a replacement piece of tubing using the old tubing
as a pattern.
(d)
Place replacement compression nuts and sleeves on each end of new tubing.
(e)
Place replacement tubing into position and tighten compression nuts at connectors.
(f)
Turn on water supply at the supply tank and check fittings for leaks. Tighten as necessary to stop
leaks.
(g)
Position tubing on shelter wall and secure with clamps and screws.
Section XIII. MAINTENANCE OF AIR CONDITIONER AIR INTAKE FILTER
4-28. General
A removable air filter, installed in the air conditioner intake louver, permits filtered outside air to enter the air
conditioner.
4-29. Air Conditioner Air Intake Filter
a.
Removal. To inspect the air filter, remove as follows:
(1)
Remove the eight screws attaching the air conditioner air intake louver to the right exterior shelter wall.
(See fig. 4-15.)
4-34
