TM 5-3610-295-13&P-1
4-29.
PHOTOTYPESETTER ASSEMBLY. - Continued
e. Replace Controller. (See Figure 4-35.)
(1) Disconnect controller power cable from wall receptacle.
(2) Raise hinged table top (1) and secure in raised position with hook-and-pile fastener (2).
(3) Remove thumbscrews (3) from front edges of controller mounting plate (4).
(4) Slide controller (5) forward off shock controller bracket (6).
(5) Tag and disconnect keyboard, monitor, and typesetter cables. Unplug power cable from controller (5) and
lay controller (5) on side.
(6) Remove bolts (7), lockwashers (8) and flat washers (9) and remove mounting plate (4).
(7) Lay replacement controller (5) on side, align holes in mounting plate (4) with holes in bottom of controller (5)
and secure in place with flat washers (9), lockwashers (8), and bolts (7).
(8) Raise controller (5) to upright position and connect keyboard, monitor, typesetter, and power cables.
(9) Slide controller (5) into position over shock controller bracket (6) and install thumbscrews (3) into mounting
plate (4).
(10) Unfasten hook-and-pile fastener (2) and lower hinged table top (1) onto top of controller (5).
4-87
