TM 5-3610-295-13&P-1
4-29.
PHOTOTYPESETTER ASSEMBLY. - Continued
b. Replace Digital Slave Typesetter. (See Figure 4-32.)
(1) Disconnect power cord (1).
(2) Open top of typesetter (2).
(3) Remove bolts (3), lockwashers (4), flat washers (5) and backing plate (6).
(4) Remove thumbscrew (7) and flat washer (8) from upper bracket assembly (9).
(5) Slide digital slave typesetter (10) forward until screws (11) align with holes (12) in front end of bottom support
brackets (13), and remove screws (11).
(6) Roll digital slave typesetter forward and remove communications cable (14).
WARNING
Digital slave typesetter weighs approximately 300 lbs. Have sufficient personnel available to
move or lift equipment. Serious injury could result if heavy equipment is moved or lifted without
sufficient personnel.
(7) Lay digital slave typesetter on side and remove screws (15), lockwashers (16) and flat washers (17) from
upper bracket assembly (9).
(8) Remove bolts (18), lockwashers (19), flat washers (20), casters (21), spacers (22), and remove digital slave
typesetter (10) from shelter.
WARNING
Digital slave typesetter weighs approximately 300 lbs. Have sufficient personnel available to
move or lift equipment. Serious injury could result if heavy equipment is moved or lifted without
sufficient personnel.
4-81