TM 5-3610-295-13&P-1
4-22. RUB-UP BOARD AND MOUNTING ASSEMBLY. - Continued
c. Repair. - Continued
(3)
If damaged, replace rubber pad.
(4)
Remove rubber pad (1) from rub-up board (2) with putty knife.
WARNING
DEATH or serious injury could result by repeated and/or prolonged
breathing and/or liquid skin contact of dry cleaning solvent P-D680. Use in
a well-ventilated area. Do not use near open flame or in excessive heat.
The flash point of this solvent is 100 F 138 F (38 C - 59 C).
(5)
Remove adhesive from rub-up board. Use drycleaning solvent (Appendix E, item 17.)
NOTE
Allow the cementing compound sufficient time to dry (at least 48 Hours)
before cleaning the rub-up board assembly.
(6)
Apply adhesive (Appendix E, item 2) to rubber pad (1).
(7)
Position rubber pad (1) on rub-up board (2).
4-55
