TM 5-3610-295-13&P-1
4-33. AIR CONDITIONER ASSEMBLY. - Continued
b. Replace Air Conditioner. - Continued
(10)
From inside of shelter cut RTV sealant between air conditioner (2) and inner frame (3) (two
layers).
(11)
Remove air conditioner (2) and lower to the ground.
(12)
Remove nuts (4), lockwashers (5), and flat washers (6).
(13)
Cut RTV sealant holding collar (7) to shelter wall and remove collar (7).
(14)
Drill out rivets (8) and pry off handle covers (9).
(15)
Clean RTV sealant from handle covers (9), collar (7), and outer frame (10).
CAUTION
When drilling holes in air conditioner, care MUST be taken not to damage
condenser or evaporator coils or wiring.
(16)
Drill out rivets (11) and remove cover latches (12) from old air conditioner (2).
(17)
Remove screws (13) from old air conditioner (2).
(18)
Remove screws (14), flat washers (15), and canvas cover (16) from replacement air conditioner
(2).
(19)
Drill out rivets (17) and remove front handles (18) from replacement air conditioner (2).
(20) Position cover (19) on replacement air conditioner (2). Locate cover latch positions and drill
mounting holes. Install cover latches (12) on replacement air conditioner with rivets (11).
(21) Install canvas cover (16), flat washers (15), and screws (14) on old air
conditioner (2).
(22)
Install screws (13) on replacement air conditioner (2).
(23) Chisel off rivets (20) and remove data plates (21), (22), and (23) from replacement air
conditioner (2) and relocate to positions (24), (25), and (26) shown in Figure 4-42 and install with rivets (27).
4-101
