TM 5-3610-294-13&P
4-13. CARGO DOOR VENT ASSEMBLY. - Continued
(k) Place main circuit breaker on power distribution panel in ON position.
(j)
Operate air conditioner unit.
(m) Open vent door.
(n) Operate air conditioner unit. Air conditioner units should operate properly when all vent doors are opened.
(4) Replace Cargo Door Vent Assembly.
(a) Place main circuit breaker on power distribution panel in OFF position.
(b) Remove screw (8) and switch cover (9) and disconnect wiring (11) from push button switch.
(c) Using an electric drill, drill out all rivets (3) on vent assembly frame.
(d) Remove cargo door vent assembly (2).
(e) Remove RTV sealing compound around opening for cargo door vent assembly frame.
(f)
Lay a bead of RTV sealing compound along edge of vent door opening.
(g) Position replacement cargo door vent assembly over holes in cargo door.
(h) Using riveter, install blind rivets (3) in vent assembly housing (10).
(i)
Reconnect wiring (11) to push button switch and attach switch cover (9) with screw (8).
(j)
Place main circuit breaker on power distribution panel in ON position.
4-14. AIR CONDITIONER ASSEMBLY. (24,000 BTUH and 36,000 BTUH). Refer to figure 4-3 for location of
components and hardware on the air conditioner assembly.
This task covers: Replace
INITIAL SETUP
Tools
Electrical Equipment Tool Kit, Appendix B
General Mechanics Automotive Tool Kit, Appendix B
Fork Lift
Materials
None
NOTE
The following procedure is for the 36,000 BTUH air conditioner assembly. The
procedure for the 24,000 BTUH air conditioner assembly is similar.
4-23
