TM 5-3610-294-13&P
3-6. GENERAL. - Continued
Table 3-1. Operator Troubleshooting - Cont.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
9.
PAPER CUTTER ASSEMBLY FAILS TO OPERATE.
Step 1.
Check power distribution panel circuit breaker to make sure it is on.
Set power distribution panel circuit breaker to ON.
Step 2.
Refer to TM 5-3610-299-12&P, Paper Cutter Operation and Maintenance manual to make sure paper
cutter is set up for operation.
Program paper cutter for operation.
10.
POWER DISTRIBUTION BOX ASSEMBLY DOES NOT OPERATE PROPERLY.
Ensure that power cable from power source is connected and that power is on.
Connect power cable and energize power source.
Notify unit maintenance of trouble.
11.
LIGHT TABLE WILL NOT ILLUMINATE.
Ensure that power cable is connected and that power is on.
Connect power cable and/or turn light table on.
Check for defective fluorescent tubes.
If necessary, refer to Unit Maintenance for service/repair.
12.
FLIP-TOP PLATEMAKER.
Refer to TM 5-3610-305-12&P for troubleshooting procedures.
Change 1
3-9/(3-10 Blank)
