TM 5-3610-294-13&P
4-27. EMERGENCY LIGHT. - Continued
a.
Replace.
(1)
Unplug power cord (1) from wall outlet.
(2)
Remove screws (2) and cover (3).
(3)
Remove screws (4), lockwashers (5), flat washers (6), and emergency light (7).
(4)
Position replacement emergency light (7) and secure using flat washers (6), lockwashers (5), and
screws (4).
(5)
Position cover (3) and secure with screws (2).
(6)
Plug in power cord (1), turn on power, and test operation.
b.
Repair.
(1)
Repair by replacing sealed beam lamp.
NOTE
The following procedure is for one sealed beam lamp. The other is the same.
(a)
Unplug power cord (1) from wall outlet.
(b)
Turn retaining ring (8) counterclockwise and remove.
(c)
Tag and disconnect electrical wires (9) by loosening screws (10) and remove sealed beam lamp (11)
from lamp housing (12).
(d)
Connect electrical wires (9) to replacement sealed beam lamp (11) by tightening screws (10) and
remove tags.
(e)
Position replacement sealed beam lamp (11) in lamp housing (12).
(f)
Install retaining ring (8) by turning clockwise.
(g)
Plug in electrical cord (1), turn on power, and test operation by pressing TEST switch.
4-69
