TM 5-3610-293-13&P
2-14. ASSEMBLY AND PREPARATION FOR USE. - Continued
NOTE
The solar bar levers on the rear end of the shelter have been removed due to lack
of clearance at the air conditioner housing. A ratchet wrench is supplied for use
in rotating the solar bar and is stowed inside the cargo door on the 36,000 BTUH
air conditioner side.
b.
Setup of Shelter. Refer to TM 10-5411-200-14 for detailed instructions for setting up the shelter.
c.
Press Section Interior Equipment. Refer to Figure 2-13 for a typical location of Press Section equipment when
setup for operation. Remove the equipment from the center section of the shelter in the order listed below using T-
handle retainer wrench located to the right of the personnel door to remove retainer bolts. Store retainer bolts in proper
location on transporter assemblies.
NOTE
Equipment stored in the center section of the shelter, with the exception of the
Printing Press, may be placed anywhere within the shelter.
2-29
